Author |
Topic: Help to remove wiring loom (Read 469 times) |
|
Danny
Full Member
Posts: 242
|
|
Help to remove wiring loom
« on: Oct 20th, 2007, 11:00am » |
Quote Modify
|
Hi all, I am bit stuck on how to remove the loom from the gearbox end. Is there away to remove and disconect without have to take the exhaust off and lower the gearbox without having to remove it.
|
|
IP Logged |
ex 1996 24v Cosworth Now - Mondeo ST TDCI (Sat Nav Built-in/Bluetooth/Voice Control/Xenons/DeCat/Bluefin Remap @ 190bhp)
|
|
|
howiedintheplace
Senior Member
Based near Evesham
Posts: 1194
|
|
Re: Help to remove wiring loom
« Reply #1 on: Oct 21st, 2007, 7:20pm » |
Quote Modify
|
Not really. It should have some clips that fix it to the top of the box. They stop you
|
|
IP Logged |
Dave
|
|
|
Danny
Full Member
Posts: 242
|
|
Re: Help to remove wiring loom
« Reply #2 on: Oct 21st, 2007, 7:48pm » |
Quote Modify
|
But I am struggling with getting access to the loom.
|
|
IP Logged |
ex 1996 24v Cosworth Now - Mondeo ST TDCI (Sat Nav Built-in/Bluetooth/Voice Control/Xenons/DeCat/Bluefin Remap @ 190bhp)
|
|
|
Matt
Senior Member
Manual'd and a 4.0 in the making
Posts: 2816
|
|
Re: Help to remove wiring loom
« Reply #3 on: Oct 21st, 2007, 7:48pm » |
Quote Modify
|
only going on my own experance here but i had to drop the box down, 1. because of the clips howiedintheplace said and 2. the plug doesnt fit through the gap between the box and the transmission tunnel
|
|
IP Logged |
FDS2000 Scans - Birmingham
|
|
|
Danny
Full Member
Posts: 242
|
|
Re: Help to remove wiring loom
« Reply #4 on: Oct 21st, 2007, 8:12pm » |
Quote Modify
|
Cheers Matt, did you remove the gearbox? or is there a bracket you can lowerto allow the gearbox to drop and give you enough room to get the clips in etc...
|
|
IP Logged |
ex 1996 24v Cosworth Now - Mondeo ST TDCI (Sat Nav Built-in/Bluetooth/Voice Control/Xenons/DeCat/Bluefin Remap @ 190bhp)
|
|
|
howiedintheplace
Senior Member
Based near Evesham
Posts: 1194
|
|
Re: Help to remove wiring loom
« Reply #5 on: Oct 21st, 2007, 8:43pm » |
Quote Modify
|
Just undo the gearbox surport + take off the heat shields. The box should drop a bit. Then try, keep removing more parts until you can actually remove it, remembering you have to refit it again one day. Don't forget the VSS & rear exhaust sensor connectors
|
|
IP Logged |
Dave
|
|
|
|