Author |
Topic: Auto box problem (Read 722 times) |
|
michaelelise
Full Member
![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif)
![](https://www.fordscorpio.co.uk/YaBBImages/avatars/blank.gif) I'm a YaBB newbie!
Posts: 154
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Auto box problem
« on: Feb 11th, 2010, 5:29pm » |
Quote Modify
|
Hi all, I have been a member on here for a while but not used it recently as I sold my last one 4 years ago and just brought another one. My question is, I recently brought a scorpio 24v 1998 on a R reg. Today I replaced the auto gearbox oil and filter and on refilling with Fuchs Titan 3000 Dextron II oil. The problem is it does not seem to want to select gear easy. If I put it into reverse I have to rev it a few times until it goes into gear and the same for drive. The thing is before doing the change it was working fine. Has anyone got any ideas or advice please. I changed the heater matrix 2 weeks ago and the heater works fine now at least there is heat in the car now. Thanks for help in advance Regards Michael
|
|
IP Logged |
|
|
|
Highlander
Moderator Expert
![*](https://www.fordscorpio.co.uk/YaBBImages/starmod.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/starmod.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/starmod.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/starmod.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/starmod.gif)
![](http://i1001.photobucket.com/albums/af132/CharlieSloan/Flags/Scotland.gif)
13 Scorpios, XR4x4, Suzuki SJ413 for off road :)
![Email](https://www.fordscorpio.co.uk/YaBBImages/email.gif)
Posts: 8244
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: Auto box problem
« Reply #1 on: Feb 11th, 2010, 5:52pm » |
Quote Modify
|
Hi Michael, is there enough oil in it? Did you check the level using the correct procedure? http://www.fordscorpio.co.uk/autogearbox.htm
|
|
IP Logged |
![](http://i8.tinypic.com/2qvxssl.gif)
on Oct 17th, 2011, 12:35pm, Simmo wrote:I give up ! Too much for an old boy! |
|
|
|
|
michaelelise
Full Member
![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif)
![](https://www.fordscorpio.co.uk/YaBBImages/avatars/blank.gif) I'm a YaBB newbie!
Posts: 154
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: Auto box problem
« Reply #2 on: Feb 11th, 2010, 6:02pm » |
Quote Modify
|
Hi Highlander, There is enough oil in the box and yes I have checked it using the correct method. Regards Michael
|
|
IP Logged |
|
|
|
PJDavis
Senior Member
![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif)
![](http://i771.photobucket.com/albums/xx357/PJJDavis123/PeteOnCludgy.jpg)
2 x 1995 Jag X300 3.2 / 4.0 (Henley) 1957 XK140
![Email](https://www.fordscorpio.co.uk/YaBBImages/email.gif)
Posts: 1474
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: Auto box problem
« Reply #3 on: Feb 11th, 2010, 9:28pm » |
Quote Modify
|
Did you replace the two 'O' rings? They sometimes get a little bit hardened, so if you just put the old ones off the old filter back on, and either of them got only slightly damaged when pressing the filter home, then it would cause problems like you describe. Remember they are two different sizes, and you can still get them from ford in packs of six I believe! If either of the 'O' rings are missing, I wouldn't even expect the gearbox to select. Bit of a b****r I know, it means taking the sump off again just to check.
|
|
IP Logged |
I love 'Movvy' 1995 Jaguar XJ6 X300 3.2 (Henley) 1995 Jaguar XJ6 X330 4.0 (Dopey) 1957 Jaguar XK140 USA (converted to RHD, and to have fitted Mk10 420G Engine with BW 65 Auto Trans)
|
|
|
Tompion
Administrator
![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif)
![](http://i.imgur.com/YwLOTZk.jpg)
1997 2.3 Ultima estate.
Posts: 2918
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: Auto box problem
« Reply #4 on: Feb 11th, 2010, 10:12pm » |
Quote Modify
|
Did you check the length of the filter bolt? The new filters need a shorter bolt or the old bolt packing out otherwise the filter wont seat onto the O rings.
|
|
IP Logged |
ABS multiplug wheel sensor pins MK IV or MK 20
|
|
|
Tons_of_fun
Full Member
![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif)
![](https://www.fordscorpio.co.uk/YaBBImages/avatars/xena.gif) Mmmm...Xena !
Posts: 978
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: Auto box problem
« Reply #5 on: Feb 12th, 2010, 7:46am » |
Quote Modify
|
Well done Tompion . You beat me to it . I would say this is the most likley culprit. Let us know how you get on
|
|
IP Logged |
Lord...Sometimes im not that bright
|
|
|
tlundkvi
Full Member
![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif)
![](https://www.fordscorpio.co.uk/YaBBImages/avatars/blank.gif) Ex. Scorpio 2.9 24V -95
Posts: 909
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: Auto box problem
« Reply #6 on: Feb 12th, 2010, 8:08am » |
Quote Modify
|
on Feb 11th, 2010, 9:28pm, PJDavis wrote:Remember they are two different sizes, and you can still get them from ford in packs of six I believe! |
| Finis are 6152081 and 6117033, if not supplied with the new filter. You can buy them individually also.
|
|
IP Logged |
|
|
|
michaelelise
Full Member
![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif)
![](https://www.fordscorpio.co.uk/YaBBImages/avatars/blank.gif) I'm a YaBB newbie!
Posts: 154
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: Auto box problem
« Reply #7 on: Feb 16th, 2010, 1:36pm » |
Quote Modify
|
Hi all, Thanks for all the information and help. The thing is I was having a blonde moment and did not check the levels properly. I took out 3 and three quarter litres of oil, so I put the same back but it needed 5 litres. Once again thanks for your help I will check better in future. Regards Michael
|
|
IP Logged |
|
|
|
|