Author |
Topic: Metric/Imperial Readings (Read 666 times) |
|
PJDavis
Senior Member
2 x 1995 Jag X300 3.2 / 4.0 (Henley) 1957 XK140
Posts: 1474
|
|
Metric/Imperial Readings
« on: Jan 5th, 2015, 10:05am » |
Quote Modify
|
My dash readings for Average fuel/average speed/temp have always been metric, i.e. in kilometres. Except my temp reading, (which I leave it on) reads in Degrees 'C'. Now yesterday I tried to change it all to MPH/MPG etc by doing as the handbook says and pressing the 'S' button, so nothing changed, except now the blasted temperature reads in Degrees 'F'! I can't seem to get it back to read 'C'? Question..................How can I return it to dgrees 'C', and does the other stuff always read in kilometres?
|
|
IP Logged |
I love 'Movvy' 1995 Jaguar XJ6 X300 3.2 (Henley) 1995 Jaguar XJ6 X330 4.0 (Dopey) 1957 Jaguar XK140 USA (converted to RHD, and to have fitted Mk10 420G Engine with BW 65 Auto Trans)
|
|
|
Tenfut
Full Member
White Cosworth Saloon
Posts: 621
|
|
Re: Metric/Imperial Readings
« Reply #1 on: Jan 5th, 2015, 10:26am » |
Quote Modify
|
Try taking the switch out, spray with electrical contact cleaner, leave a few minutes to dry then try again. I have MPG/Miles left(fuel) and temp in degrees C. Tony
|
|
IP Logged |
Everything in moderation!!
|
|
|
Tompion
Administrator
1997 2.3 Ultima estate.
Posts: 2918
|
|
Re: Metric/Imperial Readings
« Reply #2 on: Jan 5th, 2015, 1:50pm » |
Quote Modify
|
The buttons each use different value resistors via the same wire, bad connections dirty contacts, poor solder joints etc can cause the wrong resistance so nothing happens. Sometimes pressing the 2 smaller buttons at the same time will give the right resistance & get it to change. You can check the resistance as part of the dash diagnostic – but it probably won’t be of great use.
|
|
IP Logged |
ABS multiplug wheel sensor pins MK IV or MK 20
|
|
|
PJDavis
Senior Member
2 x 1995 Jag X300 3.2 / 4.0 (Henley) 1957 XK140
Posts: 1474
|
|
Re: Metric/Imperial Readings
« Reply #3 on: Jan 5th, 2015, 3:04pm » |
Quote Modify
|
I think I've got a couple of spare switches, might that be worth a try? Also, I notice when it's dark and the lights are on only the Mode and S are back-lighted, not the R, is this right?
|
|
IP Logged |
I love 'Movvy' 1995 Jaguar XJ6 X300 3.2 (Henley) 1995 Jaguar XJ6 X330 4.0 (Dopey) 1957 Jaguar XK140 USA (converted to RHD, and to have fitted Mk10 420G Engine with BW 65 Auto Trans)
|
|
|
Tompion
Administrator
1997 2.3 Ultima estate.
Posts: 2918
|
|
Re: Metric/Imperial Readings
« Reply #4 on: Jan 5th, 2015, 6:28pm » |
Quote Modify
|
They should all be lit, I think they're little LED's soldered to the board.
|
|
IP Logged |
ABS multiplug wheel sensor pins MK IV or MK 20
|
|
|
|