Author |
Topic: no PATS light at all (Read 605 times) |
|
royjenkins
Newbie
I'm a YaBB newbie!
Posts: 12
|
 |
no PATS light at all
« on: Dec 8th, 2006, 3:46pm » |
 Quote  Modify
|
dear all
I am a new owner and have a few small problems!!!
1) no Pats light at all, remote does not work.
2) having removed battery to treat rust now cannot use radio.
7000 with cd player
Vehicle is 2.3 auto saloon just turned 70000 miles.
Would appreciate help with these points and have found site very useful but jargon is slightly offputting!!
What does MAF mean?
I realised that OBD meant on-board diagnostics after a while.
Previous owner cant remember radio code. Is it possible to get radio code from VIN?
Thanks in advance
|
|
 IP Logged |
|
|
|
Snoopy
Administrator
Very old.BAD tempered and missing friends.
Posts: 6278
|
|
Re: no PATS light at all
« Reply #1 on: Dec 8th, 2006, 3:57pm » |
Quote Modify
|
To get the radio code you need the serial number from off the side or top of the radio.. just buy some extractors from Halfords and pull it out... PM ( private message ) me the serial number and I will send the code for the radio back by return ( In fact many of the members will do that for you ) with regards the remote clean it all out and reprogramme according to the site ... HERE
you will find most of the site is best accessed from the index which is INDEX
PATS is Passsive anti theft system and
MAF is mass Airflow Sensor ..
|
|
IP Logged |
HELP the FORUM.Please DONATE
|
|
|
Baz
Moderator
Senior Member
S Reg. 1998 24v Cosworth S2.9 COS (Deceased)
Posts: 4009
|
|
Re: no PATS light at all
« Reply #2 on: Dec 8th, 2006, 7:24pm » |
Quote Modify
|
Dave,
did you notice that the last site update according to index2 is back in 2005!!?
|
|
IP Logged |
|
|
|
scorpio_man
Administrator
Ford Kuga awd
Posts: 5654
|
|
Re: no PATS light at all
« Reply #3 on: Dec 8th, 2006, 7:53pm » |
Quote Modify
|
hi there
shows how much work eric put into cleaning up the site last year/early this year.
|
|
IP Logged |
|
|
|
royjenkins
Newbie
I'm a YaBB newbie!
Posts: 12
|
|
Re: no PATS light at all
« Reply #4 on: Dec 13th, 2006, 1:26pm » |
Quote Modify
|
From royjenkins
Thanks for your replies.
I've managed to obtain the radio code and it works.
Will probably try some things over Xmas with regard to the PATS.
I've been searching the site and there is a lot of good stuff here.
Best Wishes
royjenkins
|
|
IP Logged |
|
|
|
scorpio_man
Administrator
Ford Kuga awd
Posts: 5654
|
|
Re: no PATS light at all
« Reply #5 on: Dec 13th, 2006, 1:53pm » |
Quote Modify
|
hi there
re the PATS light. the light is about 2 or 3" below the dash. what you see on the dash is just a cover on a tube. maybe the 'real' unit has moved a bit underneath?
hth
|
|
IP Logged |
|
|
|
harry.m1byt
Full Member
What's YaBB?
Posts: 792
|
|
Re: no PATS light at all
« Reply #6 on: Dec 13th, 2006, 6:49pm » |
Quote Modify
|
My PATS/alarm warning light didn't work when I got the car a month or two ago. It was the first of the defects I rectified and took me just seconds to sort out and accidently at that.
The bit you see on top of the dash is just a cover for the light and lifts off. The actual light (red LED) is set some way below. I felt down the hole with little finger and (I guess) pushed the LED more firmly into its socket, after which it started to work. It is not very bright, only really visible in the dark. It lights up briefly after tuning the igintion on, when you lock it activating the alarm and gives a short flashes after that.
|
|
IP Logged |
August '95 2.9 12v auto Ultima -
Now flashing 
|
|
|
royjenkins
Newbie
I'm a YaBB newbie!
Posts: 12
|
|
Re: no PATS light at all
« Reply #7 on: Dec 18th, 2006, 4:45pm » |
Quote Modify
|
From royjenkins
Thanks for all the messages. Tried reprogramming remote control on Sunday - no joy, not even a beep!! the seat memory works though, well I got a beep when I set it so we'll have to look more deeply. Will keep you informed.
Best Wishes and Merry Xmas
royjenkins
|
|
IP Logged |
|
|
|
|
Home
Help
Search
Members
Login
Reply
Send Topic
Print