Author |
Topic: 16v ultima oil cooler pipes. (Read 415 times) |
|
joe-satch
Senior Member
![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif)
![](https://www.fordscorpio.co.uk/YaBBImages/avatars/blank.gif) joe satriani is the best guitarist in the world.
Posts: 1161
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
16v ultima oil cooler pipes.
« on: Oct 27th, 2007, 11:26am » |
Quote Modify
|
hi all, i was under the daughters ultima yesterday....and i noticed that the two auto transmission oil cooler pipes are some what crushed at the point just under the engine sump..some careless past owner not paying attention to what he was doing....oh well i will fined some in the local scrapyard...in the not to distant future..i dont want to try to squeeze the pipes open..as i would think that they could crack..and then leak..so best left alone for now...replaced the lower wishbone rear rubber bush...no problems with that job,took about 15mins...anyway have funand be safe out there...regards joe-satch. .
|
|
IP Logged |
|
|
|
Snoopy
Administrator
![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif)
![](https://www.fordscorpio.co.uk/YaBBImages/avatars/angryboy.gif) Very old.BAD tempered and missing friends.
![Email](https://www.fordscorpio.co.uk/YaBBImages/email.gif)
Posts: 6278
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: 16v ultima oil cooler pipes.
« Reply #1 on: Oct 27th, 2007, 2:37pm » |
Quote Modify
|
They Can be cut back and Fuel Pipe substituted in its place and use good jubilee clips to secure. There is NOT a lot of pressure in the system .
|
|
IP Logged |
HELP the FORUM.Please DONATE
|
|
|
joe-satch
Senior Member
![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif)
![](https://www.fordscorpio.co.uk/YaBBImages/avatars/blank.gif) joe satriani is the best guitarist in the world.
Posts: 1161
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: 16v ultima oil cooler pipes.
« Reply #2 on: Oct 28th, 2007, 10:09am » |
Quote Modify
|
hi and thank you snoopy,yes...that would save a lot of hunting around for replacement pipes to fit..i think i will give your suggestion a go...maybe one day this week...weather permiting and if i can get rid of this dam cold... ..thanks again...regards den.
|
|
IP Logged |
|
|
|
bizzay1
Full Member
![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif)
![](http://img424.imageshack.us/img424/9182/pafc1kd.jpg)
1997 Cosworth Saloon
Posts: 481
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: 16v ultima oil cooler pipes.
« Reply #3 on: Oct 28th, 2007, 8:10pm » |
Quote Modify
|
As snoopy says use fuel pipe, After replacing the small pipe that goes between the cooling radiator and the main rad at a cost of £28 for a new pipe, I used 9mm fuel pipe to repair the other pipe as I didn't like to think how much that was from FMd. Cut the old bad bit out with a plumbers pipe cutter to give a nice cut, 9mm pipe is tight to get on the metal pipe and then fitted 2 jubillee clips on each end to make sure it's very secure, but as stated earlier there is very little pressure anyways.
|
|
IP Logged |
|
|
|
Dave
Senior Member
![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif)
![](http://img.photobucket.com/albums/v467/missterdave/Hosting/Ball.gif)
Tourmallard 24v (ex-owner)
![Email](https://www.fordscorpio.co.uk/YaBBImages/email.gif)
Posts: 1984
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: 16v ultima oil cooler pipes.
« Reply #4 on: Oct 28th, 2007, 9:29pm » |
Quote Modify
|
Excellent advice chaps, need to do mine this week
|
|
IP Logged |
Life after the Scorpio ain't easy..
|
|
|
joe-satch
Senior Member
![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif)
![](https://www.fordscorpio.co.uk/YaBBImages/avatars/blank.gif) joe satriani is the best guitarist in the world.
Posts: 1161
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: 16v ultima oil cooler pipes.
« Reply #5 on: Oct 29th, 2007, 11:40am » |
Quote Modify
|
hello,i will carry out that advice this wekk i hope...thank you..regards den.
|
|
IP Logged |
|
|
|
|