Author |
Topic: ABS LIGHT (Read 1280 times) |
|
gost
Full Member
I'm a YaBB newbie!
Posts: 491
|
Hi gents, had my 2.3 since November, ABS light nalways on, was told it was needing a new pump complete, bought a second hand pump and had ity fitted tody, light still on and computer reads no faults!! Ant ideas
|
|
IP Logged |
2.3 ultima
|
|
|
TiberiuS
Senior Member
Ex. 1996 2.3 Ultima - RIP P789 KHJ
Posts: 2257
|
|
Re: ABS LIGHT
« Reply #1 on: Apr 16th, 2008, 7:57pm » |
Quote Modify
|
Hi. Is the lamp on all the time or just above 15mph? What Teves version is it? Did you replace the ECU in the plastic box bolted to the pump as well? Lamp on ALL the time could point to bad loom or broken/shorted wheel sensor, the other guys will know more. Regards, Bruce.
|
|
IP Logged |
Bruce - '07 Jaguar XKR coupe, '95 Jaguar XJ Sport 4.0, '82 Ford Capri 2.0 Ghia, '15 Honda Civic (sloooooww..)
|
|
|
gost
Full Member
I'm a YaBB newbie!
Posts: 491
|
|
Re: ABS LIGHT
« Reply #2 on: Apr 16th, 2008, 8:02pm » |
Quote Modify
|
Hi Bruce, light is on all the time, dont know what was replaced yet just picked car up, but i bought a replacement pump complete from breakers up north, i assume it was complete, apparently light has been on for past year
|
|
IP Logged |
2.3 ultima
|
|
|
TiberiuS
Senior Member
Ex. 1996 2.3 Ultima - RIP P789 KHJ
Posts: 2257
|
|
Re: ABS LIGHT
« Reply #3 on: Apr 16th, 2008, 8:11pm » |
Quote Modify
|
Yeah, usually the pump/ECU are bundled together, just checking. If it were my car then a wiring loom fault or shorted/open circuit wheel sensor would be my next suspect, you can check the wheel sensors for broken coil, short circuit etc with a basic multimeter at the main connector plug at the pump/ECU unit...pinouts are on the site somewhere. Hopefully one of the other guys can chime in with more info. Regards, Bruce.
|
|
IP Logged |
Bruce - '07 Jaguar XKR coupe, '95 Jaguar XJ Sport 4.0, '82 Ford Capri 2.0 Ghia, '15 Honda Civic (sloooooww..)
|
|
|
Octavian_P
Senior Member
Posts: 1126
|
|
Re: ABS LIGHT
« Reply #4 on: Apr 17th, 2008, 5:04pm » |
Quote Modify
|
When i bought my 2.3 it had the ABS light all the time. I have checked the sensor, they where OK, i have measured the plug on the ABS was ok, so the only problem that remained was the module. I have bought one from a break yard from Germany and mounted it on the car.....same result, light on. After some time Tompion a member here discovered that there's a dry joint in the module which needs re-soldering. Sooo... 1) have a read here first: http://www.fordscorpio.co.uk/abssystem.htm 2) If the first part doesn't help then read this: http://www.fordscorpio.co.uk/abscontrollerrepair.htm PS: both my modules had the no 2 problem.
|
|
IP Logged |
2.0 16V Ultima|2.3 16V Ghia|2.9 24V Cosworth Ghia
|
|
|
gost
Full Member
I'm a YaBB newbie!
Posts: 491
|
|
Re: ABS LIGHT
« Reply #5 on: Apr 17th, 2008, 6:28pm » |
Quote Modify
|
Thanks for that Octavian, guess i will have to take bull by the horns and have a go,
|
|
IP Logged |
2.3 ultima
|
|
|
|