Author |
Topic: faulty speedo needle (Read 488 times) |
|
Savvy
Full Member
![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif)
![](http://i271.photobucket.com/albums/jj130/chris_2909/n556302632_476904_45.jpg)
98 Cosworth
![Email](https://www.fordscorpio.co.uk/YaBBImages/email.gif)
Posts: 205
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
faulty speedo needle
« on: Jan 10th, 2009, 1:30pm » |
Quote Modify
|
Apologies if this is double posted, forum looks a little odd on my blackberry But my speedo needle has spun round to the other side of the dial (on start up because my battery is a little flat) Instead of returning to normal position, it dropped and now points downwards How can I get it back to normal without taking it apart? I'm miles from home!
|
|
IP Logged |
VX220 2.2 Y Reg Cosworth Ultima
|
|
|
Simmo
Administrator
![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif)
![](https://www.fordscorpio.co.uk/YaBBImages/avatars/blank.gif) I'm an OAP !
Posts: 5508
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: faulty speedo needle
« Reply #1 on: Jan 10th, 2009, 1:47pm » |
Quote Modify
|
It may be difficult if you don't have access to tools but it has been done by making a tiny hole in the clear cover,inserting a thin piece of wire and 'hooking' it back over the stop pin.
|
|
IP Logged |
Now I'm an OAP
|
|
|
Savvy
Full Member
![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif)
![](http://i271.photobucket.com/albums/jj130/chris_2909/n556302632_476904_45.jpg)
98 Cosworth
![Email](https://www.fordscorpio.co.uk/YaBBImages/email.gif)
Posts: 205
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: faulty speedo needle
« Reply #2 on: Jan 10th, 2009, 1:54pm » |
Quote Modify
|
Is it a dead needle until I can physically move back round? I can buy some tools if needed, though I'm guessing removing it all isn't a quick job
|
|
IP Logged |
VX220 2.2 Y Reg Cosworth Ultima
|
|
|
Tompion
Administrator
![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif)
![](http://i.imgur.com/YwLOTZk.jpg)
1997 2.3 Ultima estate.
Posts: 2918
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: faulty speedo needle
« Reply #3 on: Jan 10th, 2009, 2:06pm » |
Quote Modify
|
It’s like a little electric motor that is driven clockwise, then anticlockwise during a reset. It’s gone over the ledge at the bottom & doesn’t have enough umph to get back over the ledge. Try doing a reset (turn on ignition, press and hold reset button on instrument cluster until it goes into diagnostic mode). Turn off ignition, turn it back on & the needles will sweep round, when the rev counter reaches the stop (about to return to zero) give the top off the dash a clout & hopefully the speedo needle will jump the ledge & go back.
|
|
IP Logged |
ABS multiplug wheel sensor pins MK IV or MK 20
|
|
|
Savvy
Full Member
![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/star.gif)
![](http://i271.photobucket.com/albums/jj130/chris_2909/n556302632_476904_45.jpg)
98 Cosworth
![Email](https://www.fordscorpio.co.uk/YaBBImages/email.gif)
Posts: 205
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: faulty speedo needle
« Reply #4 on: Jan 10th, 2009, 2:12pm » |
Quote Modify
|
You are a legend! I ran out the supermarket leaving the good lady to pay to try that It worked!!! Will be so worth the grief I'm about to get You've made my day :d
|
|
IP Logged |
VX220 2.2 Y Reg Cosworth Ultima
|
|
|
Tompion
Administrator
![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif)
![](http://i.imgur.com/YwLOTZk.jpg)
1997 2.3 Ultima estate.
Posts: 2918
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: faulty speedo needle
« Reply #5 on: Jan 10th, 2009, 2:25pm » |
Quote Modify
|
Glad it worked
|
|
IP Logged |
ABS multiplug wheel sensor pins MK IV or MK 20
|
|
|
Simmo
Administrator
![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif) ![*](https://www.fordscorpio.co.uk/YaBBImages/staradmin.gif)
![](https://www.fordscorpio.co.uk/YaBBImages/avatars/blank.gif) I'm an OAP !
Posts: 5508
|
![](https://www.fordscorpio.co.uk/YaBBImages/xx.gif) |
Re: faulty speedo needle
« Reply #6 on: Jan 10th, 2009, 6:42pm » |
Quote Modify
|
Is there no end to this mans talents!!! . Dave you are a diamond. Mike.
|
|
IP Logged |
Now I'm an OAP
|
|
|
|