Ford Scorpio Forum - Print Page


    
      
        Ford Scorpio Forum
        (https://www.fordscorpio.co.uk/cgi-bin/yabb/YaBB.pl)
      

        General >> Give/Need advice to/from others >> squeek
        
(Message started by: bizzay1 on May 28^th, 2006, 7:36pm)

Title: squeek
Post by bizzay1 on May 28^th, 2006, 7:36pm

I get a squeek from my blower fan if it runs at a certain speed, I seem to remember reading that somebody else had this problem and was pointed toward a page explaining how to squirt wd 40 onto the motor without too much hassel to sort this annoying problem out, anybody know what I'm on about or have I been dreaming ??

Title: Re: squeek
Post by scorpio_man on May 28^th, 2006, 8:03pm

hi there

just take out the hbc from under the windsceen.

10 mins work. :)

btw, don't go mad with the wd40. bit smelly! ;D

Title: Re: squeek
Post by bizzay1 on May 28^th, 2006, 8:37pm

thanks for the reply, I'll look at that, knew I'd read it somewhere

Title: Re: squeek
Post by Simmo on May 29^th, 2006, 7:16am

I think this is what you are thinking of.http://www.fordscorpio.co.uk/cgi-bin/yabb/YaBB.pl?board=admin4;action=display;num=1133086555. Reply no 1.

Title: Re: squeek
Post by deefer on May 29^th, 2006, 1:57pm

hbc ?

Title: Re: squeek
Post by Simmo on May 29^th, 2006, 2:44pm

Heater blower control. This should help you locate it. Centre of car at rear of engine. http://www.fordscorpio.co.uk/acindex.htm. There is also a picture here http://www.fordscorpio.co.uk/acdrain.htm. The unit is just visible behind the bulkhead dead centre and you can see a purple/black wire which is one of the connectors to the HBC. Disconnect the wires undo the screws and the HBC will lift out enabling you to see inside.