|
||
Title: No spark Post by mark_erdington on Aug 15th, 2006, 8:20pm I have just finished fitting new timming chains to my 2.9 24v cossie,come to start it and nothing.it turns over fine,but I have no spark.can anybody help ??? |
||
Title: Re: No spark Post by Highlander on Aug 15th, 2006, 8:29pm throttle stuck open? |
||
Title: Re: No spark Post by mark_erdington on Aug 15th, 2006, 8:43pm No that works fine |
||
Title: Re: No spark Post by sector-9 on Aug 15th, 2006, 9:41pm Unlikely all three coils have died so check that you've reconnected all the wires to the battery, and that you haven't knocked the inertia cutout switch. Darren |
||
Title: Re: No spark Post by hellblue on Aug 15th, 2006, 9:44pm If all is reconnected ok, hows the wiring loom? have a good look around cam & crank sensor wiring,coil & earth wires,& any other wiring you may have moved as you may well know these are prone to engine loom probs... |
||
Title: Re: No spark Post by howiedintheplace on Aug 15th, 2006, 10:08pm There is no easy answer here but first you need to look at what you have removed & refitted. No.1 front pulley & crank sensor. Are they fitted correctly as this is where the whole spark process starts. |
||
Title: Re: No spark Post by mark_erdington on Aug 16th, 2006, 7:14pm Ive checked all conections and they look ok,but the cables are badly cracked,so how easy is it to change the loom between the V section, |
||
Title: Re: No spark Post by Dave on Aug 17th, 2006, 5:52pm I reinsulated this loom, required the inlet manifolds removing but it wasn't too bad a job. Make sure that you check the crank sensor wiring as mine were touching each other due to failed insulation causing no spark. |
||
Title: Re: No spark Post by mark_erdington on Aug 17th, 2006, 7:15pm ok Ive started to re wire the loom, |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |