|
||
Title: Sticking on Ford Badges Post by Scorpius on Feb 27th, 2007, 9:41am Does anyone have any suggestions for the best way to stick Ford badges back on with? Tried double sided tape and spray glue with no luck. Ian |
||
Title: Re: Sticking on Ford Badges Post by jonnycab on Feb 27th, 2007, 9:53am Hi mate......Have you tried double sided foam pads....usually about 1mm thick |
||
Title: Re: Sticking on Ford Badges Post by macroy on Feb 27th, 2007, 12:12pm Hi,get some double sided tape from your motor store,use some pre-clean to the area and make sure it is thoroughly dry,use a hair dryer to warm up both surfaces and stick on the badge.This is the method used in our local bodyshop.Roy ;) |
||
Title: Re: Sticking on Ford Badges Post by Spannerdemon on Feb 27th, 2007, 3:03pm Another way is to rough up the back of the badge slightly with a dremel tool or a small wire brush, to form a good 'key' and then apply the double sided sticky pad. Ensure that the area you are going to apply the badge to to is 100% dry. it's worth getting the special pad, but if you can't then get a mirror pad or two from your nearest motor shop, and trim them to size. I've got a Scorpio badge on the back of my Ultima, put on like this, and it's been there for over a year now and is as solid as if it was part of the car. |
||
Title: Re: Sticking on Ford Badges Post by craig on Feb 27th, 2007, 5:17pm instead of "sticky pads" you could always use the more powerfull adhesive pads that you can buy in most motor facors etc. that are used to hold the interior mirror in place.... ;) |
||
Title: Re: Sticking on Ford Badges Post by TiberiuS on Feb 27th, 2007, 5:32pm Use the stuff on a roll you can get from Halfords, the black double-sided stuff bodyshops use ;) Or buy the local Wrigleys depot and spend an hour chewing ::) |
||
Title: Re: Sticking on Ford Badges Post by Scorpius on Feb 27th, 2007, 6:39pm Thanks Guys. Looks like a trip to Halfords is in order then. Ian |
||
Title: Re: Sticking on Ford Badges Post by rik2.3ultima on Apr 3rd, 2007, 10:48pm Silicone sealent worked for me after I colour coded the ones on a Fiesta I had once. Held true through the most vigerous of car washes Rik |
||
Title: Re: Sticking on Ford Badges Post by Scorpius on Apr 4th, 2007, 10:24pm I used to use silicone sealant back in the 80s, but the stuff doesn't seem the same these days and i didn't fancy risking it. I ended up going to Halfors and getting some 1mm adhesive pads designed for holing on number plates. Ian |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |