|
||
Title: how to change injectors please Post by dogma on Mar 29th, 2007, 7:13pm Hi all, just bought a set of low millage injectors for a 2.9 12v v6 and was wondering how hard it is to change them over, looked on the main page but couldnt find anything about them many thanks jim ;D |
||
Title: Re: how to change injectors please Post by scorpio_man on Mar 29th, 2007, 7:36pm hi there you might need to follow the instructions to page 6 (http://www.fordscorpio.co.uk/manual/engines/12v/V612VCylHeads.pdf). you would need to see how it goes. might be able to skip some bits. hth |
||
Title: Re: how to change injectors please Post by ghia-x on Mar 30th, 2007, 12:53am Hi, after removing plenim chamber, blow out/clean area where injector sit, as you dont want any debris going down the holes where injectors have been :'(. Then remove 3x torq bolts as surgested. Carefully lift injector rail, {this may have to be twisted slightly when lifting it up} all inj can then be changed :) ;). How this helps, ghia-x. |
||
Title: Re: how to change injectors please Post by howiedintheplace on Mar 30th, 2007, 12:54am The 12V is easy to do but with everything sometimes they seem to weld them selves to the fuel rail which makes a easy job very hard ;) Good Luck. |
||
Title: Re: how to change injectors please Post by dogma on Mar 30th, 2007, 5:21pm Sounds pretty simple as long as the weather holds out many thanks for your help guys jim ;D |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |