|
||
Title: Pipe on top of expansion tank Post by Waglet on May 31st, 2007, 9:50pm Had to replace a headlight bulb which meant moving the expasnsion tank out ofthe way. When I came to refit it the pipe that leaves the filler cap area was just dangling. Where should it go or is supposed to dangle? Muchos Gracias for any one with a 24V who can check for me ;) |
||
Title: Re: Pipe on top of expansion tank Post by Matt on May 31st, 2007, 10:10pm as its the 24v you should have 2 connections on the side of the header tank, one to the rad and one in free air (is an overflow/pressure release pipe and should just sit down the side of the wing pointing to the ground :) |
||
Title: Re: Pipe on top of expansion tank Post by Waglet on Jun 2nd, 2007, 11:29am Thanks Matt. However the filler cap `area` has only 1 pipe leaving, the other 2 are further below. I`ll let it dangle........ |
||
Title: Re: Pipe on top of expansion tank Post by DJWerkz on Jun 2nd, 2007, 3:49pm Cosworth actually has three pipes connected to the header tank; one connects to the rad, another connects to the v-block and the third is the free dangling/pressure relief pipe. |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |