Ford Scorpio Forum - Print Page


    
      
        Ford Scorpio Forum
        (https://www.fordscorpio.co.uk/cgi-bin/yabb/YaBB.pl)
      

        General >> Give/Need advice to/from others >> dipping reverse mirror.
        
(Message started by: v4-max aka Cheekyboy1 on Jul 7^th, 2007, 10:02am)

Title: dipping reverse mirror.
Post by v4-max aka Cheekyboy1 on Jul 7^th, 2007, 10:02am

:( ok i have had enough of this playing up, there was a thread on here awhile back about how to disconnect it but cant find it. any help much apreciated.

Title: Re: dipping reverse mirror.
Post by petehull on Jul 7^th, 2007, 10:27am

???

Is this what you're looking for?

http://www.fordscorpio.co.uk/pcmirror.htm

hth

Pete

Title: Re: dipping reverse mirror.
Post by v4-max aka Cheekyboy1 on Jul 7^th, 2007, 10:38am

thanks for the reply pete but no, i'm on about the mirror connected to the passenger door that moves when you put the car in reverse, and should return back to original position when in drive.

Title: Re: dipping reverse mirror.
Post by Simmo on Jul 7^th, 2007, 1:15pm

John, if you remove the small 'cover' in the centre of the trim piece behind the mirror mounting you will find a securing screw which may enable you to access the wiring and the connector. If not then you need to remove the door 'card' in order to access it. Make sure, if you replace it, that the cable passes behind the window track or the cable will prevent the window closing. THIS (http://www.fordscorpio.co.uk/manual/body/trim/doormirror.pdf) may help. :).

Title: Re: dipping reverse mirror.
Post by v4-max aka Cheekyboy1 on Jul 7^th, 2007, 1:23pm

cheers mike, will try it later.

Title: Re: dipping reverse mirror.
Post by petehull on Jul 7^th, 2007, 3:32pm

There are 2 cables comming from the mirror, one has a white plug and the other has a black plug it is the black plug that supplies the driving mechanism, the white one is for the heated mirror, so disconnect the black one....

hth

Pete

Title: Re: dipping reverse mirror.
Post by v4-max aka Cheekyboy1 on Jul 7^th, 2007, 4:54pm

thanks pete. 8)