|
||
Title: Cooling water Post by ColinE on Oct 29th, 2007, 2:22pm Hi Any advice please, when I first start from cold the cooling lights comes on and stays on, I stop at the paper shop switch off, do what I have to get back in start up, no light, it is doing this each time I go out, I have checked the water level in the header tank this is fine, maybe a bad connection on the senser, where can I find this? any other Ideas. Colin |
||
Title: Re: Cooling water Post by jonnycab on Oct 29th, 2007, 2:51pm The sensor goes into the water tank underneath :) |
||
Title: Re: Cooling water Post by Octavian_P on Oct 30th, 2007, 11:01am My 2.3 did exactly the same, The water level seemed fine, but my parking lot has a small incline. On a flat surface with cold water the level was a bit under minimum which was bringing the light on. When the engine heats the water increases it's volume and the light goes out :) |
||
Title: Re: Cooling water Post by harry.m1byt on Oct 30th, 2007, 5:54pm If it is similar to the Granada.... It had an hinged plastic float containing a magnet the fixed part had a magnetically operated reed switch. The hinge could become a little sticky in operation, sometimes showing a false low level. |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |