|
||
Title: rear shocker Post by JimmyJaffa on May 28th, 2008, 8:44pm Hi, has anyone out there have a rear shocker (96 saloon) off the vehicle , if so would you be able to measure eye to eye when its at full legnth and eye to eye when its fully depressed, would be very greatful as it would mean i would'nt have to remove mine, many thanks, jim. |
||
Title: Re: rear shocker Post by gozz on May 28th, 2008, 10:32pm Jim. 69.5cm 41.5cm GOZZ. |
||
Title: Re: rear shocker Post by jonnycab on May 29th, 2008, 3:19am Hi Jimmy....would I be right in thinking that you are wondering whether estate springs will fit okay with your current shocks ? If so, then then the answer is yes...... ..... I fitted a pair of estate springs to my saloon & they sit fine with the saloon shocks. But you'll have to unbolt the shocks at the bottom to remove & insert the springs :) Apologies if this isn't what you were getting at :) |
||
Title: Re: rear shocker Post by JimmyJaffa on May 30th, 2008, 7:12pm Hi gozz, thanks for the quick reply and info. jonnycab, i was wondering about going down the air levelling shocker route but i might just go for estate rear springs and spring assist pads. |
||
Title: Re: rear shocker Post by jonnycab on Jun 1st, 2008, 2:49am Wise choice ;)....as I'm not sure the self levelling shocks will fit in a saloon being that it's a different set up.... ......saloon shocks are mounted behind the springs & estate shocks are mounted inside the springs. So the only way you'd be able to get a pair of self levellers to fit a saloon, would be to replace the radius arms with those from an estate :) |
||
Title: Re: rear shocker Post by gozz on Jun 1st, 2008, 4:35pm Jim. Monroe Loadleveller kit LA 355 is fitted as replacement on nearly all my funeral vehicles as the Ford mighty priced ones wear out.Mine however have the Ford self levelling system fitted with level detector and compressor as factory fitted.They would fit yours,but you would need to put the inflator valve and gauge into your boot. GOZZ. |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |