|
||
Title: Torx Size For CV Removal Post by GrumpyOne on Jun 24th, 2009, 9:19am HI All Does anyone know what size Torx bit is needed to remove the CV joints on a 24V Scorpio? Cheers Colin |
||
Title: Re: Torx Size For CV Removal Post by scorpio_man on Jun 24th, 2009, 10:34am hi there iirc, it a t30 bit. hth |
||
Title: Re: Torx Size For CV Removal Post by GrumpyOne on Jun 24th, 2009, 11:29am Thanks you are a lifesaver, now I just need superman to come round and loosen off the hub carrier bolts for me :) Thanks Colin |
||
Title: Re: Torx Size For CV Removal Post by Highlander on Jun 24th, 2009, 1:59pm Colin, the flange on the 24v drive pinion is 108mm, the 16v's use a 100mm one and they are interchangeable, just in case you need some more clearance. |
||
Title: Re: Torx Size For CV Removal Post by GrumpyOne on Jun 24th, 2009, 2:22pm Thanks, you are a mine of useful information, I don't have clearance issues but I did need to have the drivers side driveshaft shortened by about 5mm. If I can use the 16V ones I may not need to. ;D Cheers Colin PS: I have another couple of really good technical questions to test your Scorpio knowledge, I'll post them this evening. :) :) |
||
Title: Re: Torx Size For CV Removal Post by Scorpio_Mike on Jun 24th, 2009, 7:14pm I think it's a T-45 - I just checked on a spare driveshaft. |
||
Title: Re: Torx Size For CV Removal Post by Highlander on Jun 24th, 2009, 8:15pm T35 must be the Mondeo ;) |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |