Ford Scorpio Forum (https://www.fordscorpio.co.uk/cgi-bin/yabb/YaBB.pl)
General >> Give/Need advice to/from others >> heater matrix
(Message started by: pedropedro on Apr 9th, 2010, 3:36pm)

Title: heater matrix
Post by pedropedro on Apr 9th, 2010, 3:36pm
probably obvious, but unless you ever set the temp to "Hi", if using climate control, you can never ascertain the condition of the matrix as the blender is mixing cold air and it is never "hot". When the matrix blocks you therefore have no warning

if you set to "hi" periodically when idling and fan mid speed vents should be hot ie over 50 C.. if i had done this a year ago i would have been able to gauge the matrix's condition possibly

maybe doing this would give some warning   then flushing etc could save it possibly before it blocked completely

fortunately I was able to rescue mine recently, for the time being anyway..used forte flush ,,then back flushed matrix then used forte conditioner....hope above of some use


Title: Re: heater matrix
Post by Jonnycab on Apr 10th, 2010, 3:58am
Good advice I reckon.....regularly check that it can still blow nice & hot, even in summer  http://smilearchive.com/s/cwm/cwm/wink.gif

I wrote a similar post a couple of years back.....HERE (http://www.fordscorpio.co.uk/cgi-bin/yabb/YaBB.pl?board=news;action=display;num=1200189375)  http://smilies.blazemint.com/s/contrib/sarge/TheSmile.gif


Title: Re: heater matrix
Post by pedropedro on Apr 10th, 2010, 9:16am
Didn't realise you had already picked up on this......its not obvious... as most folk leave heater at whatever 23 and it just puts out blended warm air and matrix could be on last legs and still archive 23.

as you say even in summer check the matrix by turning to "Hi"
I reckon if spotted early it could be cleared a lot more easily

Title: Re: heater matrix
Post by Jonnycab on Apr 10th, 2010, 9:40pm
Great minds think alike  http://smilearchive.com/s/cwm/cwm/wink.gif



Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1!
YaBB © 2000-2003. All Rights Reserved.