|
||
Title: anyone around teesside willing to help Post by myrs200 on Sep 19th, 2010, 11:38pm Hi I'm about to take the top end off my 24v but lack confidance - I could do with a little advice/help Mick |
||
Title: Re: anyone around teesside willing to help Post by Simmo on Sep 20th, 2010, 6:50am This page (http://www.fordscorpio.co.uk/24vrebuildcyl.htm) and the links on the left hand side may help. :) |
||
Title: Re: anyone around teesside willing to help Post by gozz on Sep 20th, 2010, 8:35am myrs200. Four pints of Guiness,the job does it's self ;D GOZZ. |
||
Title: Re: anyone around teesside willing to help Post by myrs200 on Sep 20th, 2010, 4:59pm thats where I went wrong - I had 5 pints and it didnt do itself - must try again and again |
||
Title: Re: anyone around teesside willing to help Post by Matt on Sep 20th, 2010, 5:59pm why are you stripping the engine? the manifold has to come off left to right (looking from the front of the engine), watch the vacuum pipes as the plastic connectors snap extremely easily, the head water connector y shaped piece, on the left had side there is a link tube, use some pliers to waggle it into the main body, makes getting the right hand union easier to get off if the heads are coming off then apart from the main head bolts theres 1 allen pin in each of the head chain areas and on the left (iirc) head you need to remove a bung and remove a pin on the chain guide make a note of which came cam from where, theres a code stamped in each one this will help http://www.fordscorpio.co.uk/manual/engines/24v/24VDismantle.pdf |
||
Title: Re: anyone around teesside willing to help Post by myrs200 on Sep 20th, 2010, 6:10pm Hi Matt I'm only taking off the cam covers as the gaskets are leaking. The engine is going into a TVR and so the exhaust manifolds will not fit. Also removing Power Steering pump and A/C pump + Viscous fan. Different engine mounts and fitting to a manual MT75 box. I bought the engine already out of a scorpio and so don't have the info on what connects to what and much of the hoses have been chopped. |
||
Title: Re: anyone around teesside willing to help Post by Matt on Sep 20th, 2010, 6:14pm the BOB (scorpio) lumps dont have viscous fans, the earlier BOA did (granada) are you fitting a 2wd box? |
||
Title: Re: anyone around teesside willing to help Post by myrs200 on Sep 20th, 2010, 6:40pm it is a BOA - sorry I did not say before The box is a hybrid 2wd - V6 front and internals into a 2.0ltr rear casing. Diff now a 4.27 with proper LSD (not viscous) |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |