Ford Scorpio Forum - Print Page


    
      
        Ford Scorpio Forum
        (https://www.fordscorpio.co.uk/cgi-bin/yabb/YaBB.pl)
      

        General >> Give/Need advice to/from others >> Wiring diagrams
        
(Message started by: a900one on Mar 27^th, 2019, 8:53am)

Title: Wiring diagrams
Post by a900one on Mar 27^th, 2019, 8:53am

Where can I find the diagrams please, still cant get aircon compressor to run and fans.

Title: Re: Wiring diagrams
Post by Scorpio_Mike on Mar 27^th, 2019, 9:52am

Link in 'How to do things - Wiring diagrams'
https://skydrive.live.com/?cid=eb36f845ea9b8fb6&id=EB36F845EA9B8FB6!146#cid=EB36F845EA9B8FB6&id=EB36F845EA9B8FB6!146

Title: Re: Wiring diagrams
Post by Tompion on Mar 27^th, 2019, 10:53am

Did you try testing the fans by disconnecting the engine temp sensor & running the engine - that should put the fans on fast & demonstrate that the powertrain command module has received a command to turn the fans on.
It is the PCM that operates the fans having received a relevant signal from the temp sender or the aircon it does this by shorting either the BK/WH or BK/BU wires on the green fan relay to earth. To test the fans you can earth either for fast or slow speed.

Title: Re: Wiring diagrams
Post by Tompion on Mar 27^th, 2019, 2:24pm

The details of fan operation are here:
http://www.fordscorpio.co.uk/coolfans.htm

If disconnecting the engine coolant sensor doesn't put the fans on & you want to test the fans, rather than cutting into the PCM wire you could try unplugging the green relay & winding a strand of wire around pins 1 (Black earth in the plug) & 9 (Black/Blue) & plugging it back in - make sure it's 9 not 6 which is also close 1.
It won't hurt the PCM having pin 9 earthed.
That should put the fans on low.
As mentioned in the link above you can see in OBD if the fans are commanded on - which they may or may not be depending on why your aircon isn't working.

Title: Re: Wiring diagrams
Post by a900one on Mar 27^th, 2019, 5:45pm

Sorry for the delay Tompion, I tried to get the plug off but I could not get to move, need to look more into that. I was going to get the plug out from the compressor and try power to the clutch to see if its working. As the weather has been so good its put to one side for now, garden in a bad state due to health problems last year and needs sorting.
I have a OBD reader but have not looked with that as it may not cover fans etc.

Title: Re: Wiring diagrams
Post by brds on Mar 27^th, 2019, 7:15pm

FORSCAN has a test that runs the fans at both speeds.

Title: Re: Wiring diagrams
Post by a900one on Mar 29^th, 2019, 4:25pm

All sorted now, ran the compressor from a battery to the clutch and fans started to run. I had to put more gas in the aircon after it ran. My scanner is a Foxwell .

Title: Re: Wiring diagrams
Post by Tompion on Mar 29^th, 2019, 5:57pm

Forscan is free software that you use with an ELM327. I have a cheap Bluetooth ELM327 - works a treat with Forscan.