Ford Scorpio Forum - Print Page


    
      
        Ford Scorpio Forum
        (https://www.fordscorpio.co.uk/cgi-bin/yabb/YaBB.pl)
      

        General >> OBD Advice >> abs fault
        
(Message started by: cleave on Feb 15^th, 2007, 10:00am)

Title: abs fault
Post by cleave on Feb 15^th, 2007, 10:00am

Hi all,when the abs pump failure code comes up and a new pump is fitted will the abs light remain on untill the code/fault is reset :-/ :-/ :-/ :-/

Title: Re: abs fault
Post by scorpio_man on Feb 15^th, 2007, 10:39am

hi there

is this for the newer mk2.0 system? if so, then yes. i'm having a similar problem with a '00 galaxy.

see this. (http://www.fordscorpio.co.uk/abssystem.htm)

Title: Re: abs fault
Post by cleave on Feb 15^th, 2007, 11:30am

r reg 2.3 ultima....fitted recon abs pump eventually.Light was off for about 4 hours driving now its back on.No resetting was done after new pump fitted and sensor probs didnt show under ford diagnostics prior to new pump going on.fault from ford was abs pump failure..really doing my head in now...throwing money at a light that wont go off in real annoying noone seems to know what they r doing at my local garages plzzz help it will fail mot with the light on omg

Title: Re: abs fault
Post by scorpio_man on Feb 15^th, 2007, 11:42am

hi there

did it fail will you were driving? on was it on start up?

Title: Re: abs fault
Post by cleave on Feb 15^th, 2007, 11:56am

it was just back on ...on startup ???

Title: Re: abs fault
Post by Highlander on Feb 15^th, 2007, 12:37pm

So its showing the same code as it did before?
Possibly a wiring problem?
I had the same fault show up on a 24v which turned out to be the ABS wiring loom cracking up below the radiator

Title: Re: abs fault
Post by cleave on Feb 15^th, 2007, 12:47pm

not had diagnostic done since new pump went on ...should i get it done b4 trying anything else?

Title: Re: abs fault
Post by scorpio_man on Feb 15^th, 2007, 1:36pm

hi there

i'd look at the all the wiring first. you might spot something.

get a scan done after the check.

hth

Title: Re: abs fault
Post by cleave on Feb 15^th, 2007, 1:43pm

ok tnx btw where does all the wiring go from the pump it seems to meet a large loom not long after leaving the pump from what i can see

Title: Re: abs fault
Post by caspathescorp on May 1^st, 2007, 9:13pm

hi i know this is a old topic but have Cleaver looked at this "ABS C1095 Hydraulic Pump Motor Circuit Failure" in need/give advice, as i have gust repaired my pump.
hope this helps

Title: Re: abs fault
Post by pat on Jun 8^th, 2007, 12:51pm

Hi there. Ihave had loads of useful advice off people re-same problem. Had auto elec scan which reported that faulty ecu was the problem but fitting another has not cured it. (see topic abs update in problem forum and abs early April). The advice I have been given is well worth reading. Good luck , Pat. ;)