|
||
Title: help Post by shaun on Feb 20th, 2008, 7:51pm :-/ car 23cc ultmia... fitted new engine in my car the week end ,b4 i fitted it i swiled the engine bay out with white spirits, not water.... when i fitted engine ,it started firts turn of the key ,but run rugh changed all sencers like bottom knock ,the one on the rocker cover ,,the one on the theottel boddy ,,the fule reglator,,iac valve,,cpm,plus plugs leads,and coil packs ,put car on lap top,,and came up with p0122,and p0340, i think i mite have droped some durt in the block in the engine bay.any addvice.please help..... :'( |
||
Title: Re: help Post by Simmo on Feb 20th, 2008, 9:30pm All the codes are HERE (http://www.fordscorpio.co.uk/codes.htm) and according to the list the throttle position sensor and crankshaft position sensor are those being recorded. |
||
Title: Re: help Post by scorpio_man on Feb 22nd, 2008, 1:47pm hi there both these codes (if the sensors are faulty) would make the engine run rough. i'd check the wiring first, though. hth |
||
Title: Re: help Post by shaun on Feb 22nd, 2008, 3:26pm hi ,i had a quick look at the loom last night when i got in and i must have traped the two white wires :'( when putting engine back in ,and 1 of the wires is the throtal boddy sencer will repair them in morning ,i dident trap any outher wires ,i did fech the cacing off to make shere |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |