|
||
Title: How to separate track rod end from spindle carrie Post by pustagris on Nov 11th, 2004, 2:08pm now since i found a company in England which will help me to repair my failed steering rack , I have only the problem left, how to separate the track rod end from the spindle carrier,when dismanteling the rack from the car. I do n o t have a "Ball Joint Separator tool". In fact, I could not find any to buy. Is there an other solution to separate the rack from the car. Regards Volker (pustagris) |
||
Title: Re: How to separate track rod end from spindle car Post by craig on Nov 11th, 2004, 2:57pm not sure if i should be writing this but here goes..... a few years ago ;),what "someone i knew" ;) did was this.... undo the top nut on the track rod end,about half way,then obtain a large strong piece of wood,place this on top of said track rod end,obtain 1 large hammer,proceed to bang the wood with the said hammer,then hopefully said track rod end should be ok to remove...... "disclaimer" ;D,no children or animals were hurt during this procedure :o :o |
||
Title: Re: How to separate track rod end from spindle car Post by bazza on Nov 11th, 2004, 6:03pm All tapers can be released by a sharp hit. Leave the nut on a couple of threads and hit the outer edge square on and it'll always come off Bazza |
||
Title: Re: How to separate track rod end from spindle car Post by pustagris on Nov 12th, 2004, 10:35am Its done. Not by brutal force, but by borrowing an extractor from the local Renault work shop. I gave him 5 Euros. That is cheap in comparision to a new tool of this kind (45 Euros= 30 Pounds) Thanks for all the good advise of you all. regards Volker (pustagris) |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |