Ford Scorpio Forum - Print Page


    
      
        Ford Scorpio Forum
        (https://www.fordscorpio.co.uk/cgi-bin/yabb/YaBB.pl)
      

        General >> Problems >> CrankShaft pulley
        
(Message started by: rickyfifer on Nov 15^th, 2004, 9:01am)

Title: CrankShaft pulley
Post by rickyfifer on Nov 15^th, 2004, 9:01am

???
Have 95 Scorpio 24v which broke a timing chain. Been lucky and only bent 4 exhaust and 2 inlet valves. The problem i have is to get into the chain at the crankshaft i have to remove the pulley wheel. Do i have to use a service tool (21-147 Vibration damper remover) to remove itas all the other cars i have had the pulley wheel has been on a tappered shaft and came off with a wee knock. And suggestions on how to get it off without having to get the tool ..... would be appreciated

Title: Re: CrankShaft pulley
Post by howiedintheplace on Nov 15^th, 2004, 11:05am

Hi
I have most tools for the 24V but you are a bit to far away from me I think?
Maybe a local Ford garage will lend you one. This is what it looks like.
http://www.anyboard.net/autos/cars/scorpio/uploads/21_-_147.jpg

Title: Re: CrankShaft pulley
Post by rickyfifer on Nov 15^th, 2004, 6:18pm

thanks for the reply i called ford dealers close to me today and they suggested using a large bearing puller they said they no longer have the tool thats in the pic which i believe is the vibration damper remover and rekon i would have problems finding one but im sure i'll figure out a way to get it off thanks.

richard