Ford Scorpio Forum - Print Page


    
      
        Ford Scorpio Forum
        (https://www.fordscorpio.co.uk/cgi-bin/yabb/YaBB.pl)
      

        General >> Problems >> programing remotes
        
(Message started by: gibbio on Jan 24^th, 2005, 2:01pm)

Title: programing remotes
Post by gibbio on Jan 24^th, 2005, 2:01pm

Hi all I got a remote today for my 2.3 16v ultima (97 r plate) put in new batterys went to program it got the beebs ok but no response from remote any ideas would be helpful thanks roy

Title: Re: programing remotes
Post by gadgetmandb on Jan 24^th, 2005, 2:08pm

oPEN THE REMOTE AND CRAEFULLY take out the gubbins.. There should be a circuit board and a rubber button pad.
Put something like meths on a cltoh , kitchen towel and clean the circuit board.
Clean the back of the rubber button pad.
Clean the contacts on the batt terminals.
Check voltage on batts, i have known new batteries be dead.
re-fit all components together and close remote houseing.
re try to programme,make sure remote is held down by footwell on drivers side next to the accelerator wall,near door when programming.
if this fails remote probably broken ..

Title: Re: programing remotes
Post by gibbio on Jan 24^th, 2005, 3:09pm

did as suggested all works well now thank you another new toy to play with ;D ;D

Title: Re: programing remotes
Post by gadgetmandb on Jan 25^th, 2005, 1:03pm

Pleased to be of service.

Now you know why i am called Gadgetmandb !