Ford Scorpio Forum - Print Page


    
      
        Ford Scorpio Forum
        (https://www.fordscorpio.co.uk/cgi-bin/yabb/YaBB.pl)
      

        General >> Problems >> front bumper removal
        
(Message started by: craig on May 2^nd, 2005, 4:07pm)

Title: front bumper removal
Post by craig on May 2^nd, 2005, 4:07pm

i know this topic was covered a few months ago somewhere on here,can i find it now ???,i think the answer is no..... :( :( :(
anybody got the definitive knowledge about removing the front bumper

TIA

craig

Title: Re: front bumper removal
Post by SaveTheNight on May 2^nd, 2005, 4:36pm

Craig .. first remove the wheel arch fixings .. should be two each side .. then the inner arch fixings < one in each arch < turn plastic plug through 90 degrees> ..then remove the headlamp side covers ..then the air intake hose .. then the bumper bolts .. et voila ! ........ regards ....... STN

Title: Re: front bumper removal
Post by craig on May 2^nd, 2005, 4:45pm

sounds easy enough...

thanks...

Title: Re: front bumper removal
Post by craig on May 2^nd, 2005, 6:47pm

HERE (http://www.fordscorpio.co.uk/cgi-bin/yabb/YaBB.pl?board=Advice;action=display;num=1109626360)

is the thread i was looking for oiriginally,however glad i asked now,this didn't mention anything about the inner wing fixings.....
thanks again STN..

Title: Re: front bumper removal
Post by Pete on May 5^th, 2005, 9:38pm

On my Scorp, the turny bits are for the rear bumper, the front has 2 screws either side on the inner arch, a bolt either side next to the headlamp, you will need to remove the intake arm on the R/H side and the headlamp covers and then a bolt either side in the front x member.

hth

Pete