|
||
Title: Rear springs, changing.. Post by Scorpioen84 on Aug 30th, 2005, 10:12pm How did you take off the old once.? We changed the front once easy, but the rear once we gave up for the night.. Taking another go at it tomorrow.... We removed the suspension and let the bridge drop as far as we deared to, but it was still not enough to take of the old spring... Got the spring, ehm, squeezers and a hole garage to playaround in... So , i was thinking about cutting the springs and taking them of piece by piece... Why is it so "hard"? or are we stupid.? [] Any suggestions.? How is it done "properly".? Bear ower with my incredible choice of words here... hehe.. ;) |
||
Title: Re: Rear springs, changing.. Post by joe_murphy on Aug 30th, 2005, 10:56pm try removing the pivot bolt thatll allow it to drop that little bit more as its not attached at both ends then kind regards joe |
||
Title: Re: Rear springs, changing.. Post by Scorpioen84 on Aug 30th, 2005, 11:56pm Me and tecnical Englich.... ??? :-[ hi, can you explain pivot bolt.? is it that "big" bolt holding it at the end towards the front of the car.? How mutch more will it drop do you think.? Thanx for quik reply.! ;D :D |
||
Title: Re: Rear springs, changing.. Post by Snoopy on Aug 31st, 2005, 7:14am the whole procedure is here http://www.fordscorpio.co.uk/manual/suspension/RearRSpring.pdf |
||
Title: Re: Rear springs, changing.. Post by joe_murphy on Aug 31st, 2005, 11:55am scorpioen check out snoopys link its explains the job well kind regards joe murphy |
||
Title: Re: Rear springs, changing.. Post by Scorpioen84 on Aug 31st, 2005, 1:07pm ive even printed it... hehe.. But i did not se that crossmember guide plate last night... hope that doest the trick... if not we cutt them off... need to get it done tonight... starting on a new 180km drive tomorrow... |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |