|
||
Title: Washer Jet Removal Post by dexix on Jan 6th, 2006, 11:47am Hi guys a little help would be appreciated on this. I only get a dribble out of my passenger side washer jet and have been unable to clear it with a pin. I would like to take it out and have a proper look at it but am a little hesitant at how to do it. I managed to prise it partly up with a screwdriver from the top of the bonnet but assume I have to take the pipe off underneath - it seems really well stuck on and am afraid I might snap the connector or get it off and not be able to get the pipe back on again. Any suggestions please? http://img.photobucket.com/albums/v249/dexix/P1060006b.jpg |
||
Title: Re: Washer Jet Removal Post by mr._floppy on Jan 6th, 2006, 12:02pm Yes they are a tight fit, I can only suggest twisting the hose while pulling it gently rather than yanking it and, as you say, risking breaking it. A thin knife blade or feeler guage will be handy when removing the washer jet unit. |
||
Title: Re: Washer Jet Removal Post by dexix on Jan 6th, 2006, 1:32pm Thanks Mr F I think a couple of whiskeys to keep me calm and then I will have another go! I am sure the scorp should of come with a pull out seat from the engine bay as every job I do seems to involve me sprawled awkwardly over the engine. |
||
Title: Re: Washer Jet Removal Post by mr._floppy on Jan 6th, 2006, 3:17pm Well if you , like me , have a 195/60 R15 spare tyre round your waist then any stretching or exertion brings one out in a sweat :o So, take it easy. |
||
Title: Re: Washer Jet Removal Post by Simmo on Jan 6th, 2006, 6:59pm If removing the pipe is your main concern why not try a little warmth. A hair dryer on even a hot rag held round the pipe should be enough to soften the pipe and allow you to disconnect it without damaging the connector. |
||
Title: Re: Washer Jet Removal Post by craig on Jan 6th, 2006, 7:37pm if it helps,the securing lug of the washer jet is on the back of the jet (front of the car),had to replace 1 of mine last year,you do have to try to push that lug in from underneath at the same time as trying to manouvere the jet out,once the jet is out,you will see what i mean |
||
Title: Re: Washer Jet Removal Post by dexix on Jan 6th, 2006, 9:44pm Cheers guys I think I have a little more idea and confidence in trying now - if it all goes pear shaped you will soon know about it as there will be a posting in the spares wanted section for a new washer jet - or maybe a bonnet - or maybe a car! Depending on how my patience holds out >:( |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |