|
||
Title: rear bearing replacement Post by cossie_al on Apr 18th, 2006, 10:41pm Although the bearings were apprently good enough for the mot man, they have made the odd squeek or two. So off I whent to get the new ones. followed the instructions from the main site but the hub will not seperate from the carrier. I unbolted them in one piece from the car and improvised a press using a three tun bottle jack and a steel frame. Not wanting to damage anything beyond being able to get the car on the wheals again, I did use a bit of caution but not a lot. So have I missed something or have they over heated and welded the races in or some such thing ??? Any ideas greatly appreciated |
||
Title: Re: rear bearing replacement Post by jonnycab on Apr 19th, 2006, 1:13am When my rear o/s bearing went, it was still easy to pull the hub from the carrier even though the bearings were shot & parts had welded onto the hub. |
||
Title: Re: rear bearing replacement Post by Snoopy on Apr 19th, 2006, 6:46am It Might take a little force to get the HUB out of the carrier but not unduly, Try putting the HUB in the vice and using a peice of wood to protect the end on the hub hit it with a LARGE hammer . It may need a physical shock to release it . but I don't really think it should. |
||
Title: Re: rear bearing replacement Post by Baw_Flinger on Apr 19th, 2006, 8:25am Some hot and cold water treatment may help as well |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |