|
||
Title: Another wishbone problem Post by jonnycab on Oct 17th, 2007, 1:49am The rear part of the wishbone that the rear bush slips over is obviously screwed into the end of the cast wishbone body. There is a soft metal stud that goes through the wishbone into this add-on end part, obviously to stop it unscrewing. I've drilled out the stud & tried with all my might (maybe I'm not mighty enough ::)) to unscrew the end part, but it just won't budge ??? Has anyone ever got this part of the wishbone out before & if so, what steroids did you use ? ;D The reason I'm trying to separate the two parts is because about a year ago I replaced both wishbones. A few months later I had a problem with road holding & thought it might have been a prematurely failing bush. I removed the wishbones to inspect the bushes properly, but they were fine. On putting the wishbones back I accidentally over tightened the N/S rear bush holding nut & sheered off the end of the wishbone...doh !! ::) So I had to go to FMD & shell out for another new wishbone :( So I've still got a perfectly good wishbone (done about 5000 miles) with a sheered off end & one of the old shot ones with a good end.... ....So, old end on newish wishbone = perfectly good wishbone ;) Can it be done ? :) |
||
Title: Re: Another wishbone problem Post by Tompion on Oct 17th, 2007, 9:05am You could try heating it in case it's loctited in. Don't know what temp but a job I sometimes have to work on involves removing a 30mm thread through a plastic electrical enclosure which is just starting to melt before the thread will budge. You have to keep it hot or it resets. |
||
Title: Re: Another wishbone problem Post by jonnycab on Oct 17th, 2007, 11:05am Tompion......I have tried heating it with a small blow torch, but as you say, maybe it needs to be alot hotter before it will budge :) Maybe I'll stick it in the BBQ & leave it for a while ;) |
||
Title: Re: Another wishbone problem Post by mr._floppy on Oct 17th, 2007, 12:43pm Goshdarn, I don't think you have poblems with strength ! How did you manage to overtighten an big 18mm nut enough to shear it off ? :o |
||
Title: Re: Another wishbone problem Post by jonnycab on Oct 18th, 2007, 2:46am on 10/17/07 at 12:43:35, mr._floppy wrote:
Maybe I should lay off the Irn Bru :-/........ ;D |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |