|
||
Title: faulty speedo needle Post by Savvy on Jan 10th, 2009, 1:30pm Apologies if this is double posted, forum looks a little odd on my blackberry But my speedo needle has spun round to the other side of the dial (on start up because my battery is a little flat) Instead of returning to normal position, it dropped and now points downwards How can I get it back to normal without taking it apart? I'm miles from home! |
||
Title: Re: faulty speedo needle Post by Simmo on Jan 10th, 2009, 1:47pm It may be difficult if you don't have access to tools but it has been done by making a tiny hole in the clear cover,inserting a thin piece of wire and 'hooking' it back over the stop pin. ;) |
||
Title: Re: faulty speedo needle Post by Savvy on Jan 10th, 2009, 1:54pm Is it a dead needle until I can physically move back round? :( I can buy some tools if needed, though I'm guessing removing it all isn't a quick job :( |
||
Title: Re: faulty speedo needle Post by Tompion on Jan 10th, 2009, 2:06pm It’s like a little electric motor that is driven clockwise, then anticlockwise during a reset. It’s gone over the ledge at the bottom & doesn’t have enough umph to get back over the ledge. Try doing a reset (turn on ignition, press and hold reset button on instrument cluster until it goes into diagnostic mode). Turn off ignition, turn it back on & the needles will sweep round, when the rev counter reaches the stop (about to return to zero) give the top off the dash a clout & hopefully the speedo needle will jump the ledge & go back. |
||
Title: Re: faulty speedo needle Post by Savvy on Jan 10th, 2009, 2:12pm You are a legend! I ran out the supermarket leaving the good lady to pay to try that It worked!!! Will be so worth the grief I'm about to get You've made my day :d |
||
Title: Re: faulty speedo needle Post by Tompion on Jan 10th, 2009, 2:25pm Glad it worked ;D |
||
Title: Re: faulty speedo needle Post by Simmo on Jan 10th, 2009, 6:42pm Is there no end to this mans talents!!! :D ;D. Dave you are a diamond. Mike. |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |