Ford Scorpio Forum - Print Page


    
      
        Ford Scorpio Forum
        (https://www.fordscorpio.co.uk/cgi-bin/yabb/YaBB.pl)
      

        General >> Problems >> air/con wiring diagram
        
(Message started by: joe-satch on May 22^nd, 2009, 4:34pm)

Title: air/con wiring diagram
Post by joe-satch on May 22^nd, 2009, 4:34pm

hi to all members,
our daughter has just had the air/con regased on the ultima.the condensor was faulty,so we changed it...as i said its been regased...we started the engine and turned on the air/con...but the compressor is not running...we ran a jumper wire from the battery to the compressor and it ran...air/con works ok...but of course once we took the jumper wire off the compressor stopped...im going to check over the de-icing state over the next few days....but is there a wiring diagram for the air/con on this site??..i have a feeling its going to be needed in wire tracing if the de-icing state is ok...with luck it wont come to that...im going to bridge the wires loom side for the de-icing state to see if the compressor will run. :)...yes its bank holiday time again...and im working on cars... :)..have a nice weekend people. ;).thanks in advance for any help....regards den.

Title: Re: air/con wiring diagram
Post by Snoopy on May 22^nd, 2009, 5:39pm

Yes they are available have a look through HERE (http://cid-eb36f845ea9b8fb6.skydrive.live.com/browse.aspx/WIRING%20DIAGRAMS)

Title: Re: air/con wiring diagram
Post by gozz on May 22^nd, 2009, 5:41pm

joe.
Unplug the pressure valve,and do a bit of bridging in the socket.If it proves faulty you can replace it without degassing, there is a valve under it which closes as you unscrew it.
GOZZ.

Title: Re: air/con wiring diagram
Post by joe-satch on May 22^nd, 2009, 5:51pm

a big thank you to snoopy and gozz..gozz we did do a voltage check on that plug..loom side..no voltage was found. :)...unless the de-icing state is faulty.will have a look at the very soon..thank you both very much..regards den. :)

Title: Re: air/con wiring diagram
Post by joe-satch on May 23^rd, 2009, 1:22pm

right update....i have just bridged pins 1 and 2 at the de-icing switch..loom side...and the compressor runs ok..so judging by that....it seems that the de-icing switch is at fault.. :)..and i know where to get spares...there are 2 in a scrapyard near me. :)...so a job for me later in the week...thanks to all that helped with there replies.have a good bank holiday one and all. :)