|
||
Title: Tracing seat belt pre-tensioner fault Post by Lucien on Sep 21st, 2011, 8:23pm We've got a four-flash airbag warning code which indicates a seat-belt pre-tensioner fault. The car is a late R-reg Ultima 24V with side airbags. Is there a quick way to localise this fault or should I borrow a unit from the other car and test by substitution one at a time? Poking around this system with a multimeter is not recommended otherwise I'd compare the readings at the two connectors under the seats. Maybe someone knows of a common problem that triggers this fault code? Lucien |
||
Title: Re: Tracing seat belt pre-tensioner fault Post by Simmo on Sep 22nd, 2011, 6:41am Have you checked the connections under the seat?. They can get disturbed by the feet of rear seat passengers. :) |
||
Title: Re: Tracing seat belt pre-tensioner fault Post by Lucien on Sep 22nd, 2011, 8:38am Yes, they look OK, no sign of damage to the connectors or wiring loom that I've spotted so far. I wonder whether it's worth just taking the seats out for a closer look? Lucien |
||
Title: Re: Tracing seat belt pre-tensioner fault Post by Lucien on Sep 23rd, 2011, 7:14pm Before I start swapping these pyrotechnics, please can anyone confirm whether the fault warning (4 flashes of airbag light) will clear by itself after x drive cycles, or whether it has to be reset manually. As I don't think I have any way of resetting it, that would be a problem as I wouldn't know whether I had swapped out the bad unit. TIA Lucien |
||
Title: Re: Tracing seat belt pre-tensioner fault Post by Mike H on Sep 24th, 2011, 1:55pm Have you tried pulling the under-seat connectors apart and putting them back? Might just be a bad contact. |
||
Title: Re: Tracing seat belt pre-tensioner fault Post by Lucien on Sep 25th, 2011, 12:17pm Yes, done that, nothing unusual found. Perhaps I should do the same at the control box end of the loom. Still not sure whether any other steps are required to clear the fault code - any clues? Lucien |
||
Title: Re: Tracing seat belt pre-tensioner fault Post by Tompion on Sep 26th, 2011, 10:12pm I’ve had a code from a disconnected drivers airbag, I didn’t have to clear it when reconnected, so presumably the same applies to the pre-tensioner. |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |