|
||
Title: rough idle?? Post by spanners on Dec 20th, 2011, 5:50pm hi all. recently had my inlet manifold crack on my 2.3 and got a replacement off a ford galaxy. managed to bond in the parts that arnt present and swap the other components over. i fitted it with little trouble i even sealed the gaskets to prevent leakage. only now it seems to be running rough at idle and sometimes stalls! ive been to a garage to have diagnostics checked. faults are pointing at the inlet metering sensor and or oxygen sensor ? as i have not been near these components. could this be a different issue? for the last few months now and again the idle at start up has been a little rough but it clears. but now its much worse. ive also checked all the vacume pipes and all seems ok? any advice would be welcome. |
||
Title: Re: rough idle?? Post by 5stud on Dec 20th, 2011, 6:24pm when you fited the manifold did you take out the 2 no revtorex studs if you dident its posible you puled the pipe that goes behind the moter and into the crankcase vent its under the ex manifold |
||
Title: Re: rough idle?? Post by spanners on Dec 20th, 2011, 11:27pm yes 5stud i removed the 2 studs as it wouldnt come out without doing so. will check that because i was trying to do so until i realised this. i might have disturbed that pipe so will check that. thanks for the info mate. |
||
Ford Scorpio Forum » Powered by YaBB 1 Gold - SP 1.3.1! YaBB © 2000-2003. All Rights Reserved. |