Ford Scorpio Forum - Print Page


    
      
        Ford Scorpio Forum
        (https://www.fordscorpio.co.uk/cgi-bin/yabb/YaBB.pl)
      

        General >> Problems >> Windows global closing/opening not working
        
(Message started by: griffo on Oct 6^th, 2013, 11:27am)

Title: Windows global closing/opening not working
Post by griffo on Oct 6^th, 2013, 11:27am

I own a 95 ultima and when i hold the key in close position the windows buttons light but the windows don't close, the same with the open position, have any ideas?

Title: Re: Windows global closing/opening not working
Post by Simmo on Oct 6^th, 2013, 1:32pm

Go to Fault Finder (http://www.fordscorpio.co.uk/faultfinds.htm) scroll down to electrical and then reprogramme as described re one touch closing. This may resolve the issue. ;)

Title: Re: Windows global closing/opening not working
Post by amigafan2003 on Oct 6^th, 2013, 2:25pm

Has it ever worked? There have been a few cars where the global closing wasn't programmed on the control unit.

Title: Re: Windows global closing/opening not working
Post by griffo on Oct 8^th, 2013, 6:52pm

The reprograming didn't work, maybe it doesn't have global closing.

Title: Re: Windows global closing/opening not working
Post by Mike H on Oct 16^th, 2013, 6:05pm

My 1995 N reg Executive (lowest trim level) does it, so all must do it, must be a fault?

Lock door (either) with key, hold key at lock angle, rear windows close first then front. This means if only the fronts are open, will seem like nothing's happening for maybe a few seconds, which is the time allowed for the rears to close. Except they're not open.

Title: Re: Windows global closing/opening not working
Post by Mike H on Oct 16^th, 2013, 6:08pm

PS: you have to hold the key at the locked angle for the whole time that is needed for all the windows to close, if you let it go the window(s) will immediately stop moving and be left where they are, not fully closed.

Hope that make sense...