Ford Scorpio Forum - Print Page


    
      
        Ford Scorpio Forum
        (https://www.fordscorpio.co.uk/cgi-bin/yabb/YaBB.pl)
      

        General >> Parts Wanted >> Inlet Plenum "0" rings
        
(Message started by: Nunnspoet on May 23^rd, 2016, 6:50am)

Title: Inlet Plenum "0" rings
Post by Nunnspoet on May 23^rd, 2016, 6:50am

Good morning folks, a bit of Sunshine at last.

To business: I am after some "0" rings for my 24 valve Cossies. They are the ones that seal the sleeve of the insert in the rear right of the Inlet Plenum as you look from the front of the car.

Ford don't supply them any-more and I have no idea as to where to source some from or what to order regarding size and thickness - or what heat resistance is required.

Ideally I would like to have 8 as there are 2 per sleeve and I have 2 Cossies and would have 4 to hold in reserve.

Am I in luck? Have you got just the job for me? If not any, advice as to where I can get some from would be great.

Best regards

Mik :)

Title: Re: Inlet Plenum "0" rings
Post by Scorpio_Mike on May 23^rd, 2016, 7:31am

Try a local car spares shop - if you take one of the 'O' rings with you they might be able to match the size up for you, also check if there are any local businesses which make hydraulic hoses - they might have something.
Or, if you can measure it - outside diameter, inside diameter & thickness you might have some luck on ebay - not much you can't find there ;)

Title: Re: Inlet Plenum "0" rings
Post by Simmo on May 23^rd, 2016, 9:08am

A quick look on Google gave me This (https://www.google.co.uk/?gws_rd=ssl#q=O+rings) I have a set like the one in the red box but the link should get you what you want I guess. ;)

Title: Re: Inlet Plenum "0" rings
Post by Nunnspoet on May 24^th, 2016, 6:39am

Once again, thank you everyone 8). I shall keep you updated.

Mike :)